![](../Graphics/Logo_05.gif) ![](../Graphics/Logo_06.gif) |
|
View previous topic :: View next topic |
Author |
Message |
Jim Reid Registered User
Joined: 22 Feb 2010 Posts: 11 Location: Hamilton
|
Posted: Tue May 20, 2014 9:25 am Post subject: Steering rack phase 1 |
|
|
Hi I am having problems steering on my phase1 I had taken it off during the
Restoration when I refitted the rack i loss end off the rubber boots
To centre the rack an easy fix then fitted the ball joints the n/s was ok but the o/s was pointing in at the front of the wheel no bother just adjust
( aye right) I don't have enough tread on the rack or ball joint
Anybody help
Regards jim
Phase1
OAS 939 |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
John Plant Registered User
Joined: 07 Nov 2010 Posts: 112 Location: Herefordshire
|
Posted: Tue May 20, 2014 6:48 pm Post subject: |
|
|
Jim
I had the same problem with mine I fitted new ball joints, in the end I had to shorten the thread on the ball joints but make sure you have enough thread left to thread in so it is safe
regards
John |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
Howard Evans Registered User
Joined: 10 Apr 2009 Posts: 118 Location: Crewe
|
Posted: Tue May 20, 2014 7:15 pm Post subject: Steering Rack Phase 2 |
|
|
Interesting! I had the same problem when I fitted new joints to my phase 2 (Triumph) rack. Winding them fully in only enabled me to achieve parallel tracking rather than the toe-in I was aiming to set. Doesn't seem any the worse for it!
Suspect the manufacturer has removed material at the ball end and then had to reduce the length of the bore to maintain strength. _________________ Olympic PhII CTO 289B |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
Jim Reid Registered User
Joined: 22 Feb 2010 Posts: 11 Location: Hamilton
|
Posted: Wed May 28, 2014 3:57 pm Post subject: |
|
|
John Plant wrote: |
Jim
I had the same problem with mine I fitted new ball joints, in the end I had to shorten the thread on the ball joints but make sure you have enough thread left to thread in so it is safe
regards
John |
hi thanks for your reply after many hours looking at it trying this and that I discovered that one of the locknuts was wider than the other
So I managed to get a nut the same width it has made a differance
Regards jim |
|
Back to top |
|
![](templates/subSilver/images/spacer.gif) |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2002 phpBB Group
|